User Tools

Site Tools


esp8266_firmware_update

This is an old revision of the document!


ESP8266 - Upgrading the Firmware

The instructions below are based on my experiences whilst upgrading my ESP8266 module to firmware version 0.9.2.2

Preparation

Connect your ESP8266 module as follows: Vcc = 3.3V (needs around 300-400mA peak) Gnd = -ve ground CH_PD = Chip enable so always +ve RST = Leave floating or ground to reset GPIO0 = Normally floating but this needs to be grounded when you start the update. UTXD = Tx data connect to Txd on FTDI/Serial interface URXD = Rx data connect to Rx of FTDI/Serial interface

You also need to download the new firmware and update tool from ElectroDragon: http://goo.gl/uHM6aO The firmware tool is called XTCOM UTIL.zip

Before you start the update, make sure your ESP8266 is working normally. Connect as above but leave GPIO0 floating and access the serial interface with a terminal program such as PuTTY. Set the baud rate to either 57600 or 115200 for later models. When you power-up the ESP8266 you should see some readable text indicating that it's ready. If you get nonsense try change the baud rate. If all is well you should be able to issue AT commands and get responses. Try AT+RST which should re-start the module. AT+GMR should give the firmware version. If all is well you can move on to the firmware update.

Firmware Update

Her are the steps required to update the firmware:

  1. Put the ESP8266 into firmware update mode by grounding GPIO0 and re-cycling the power.
  2. Launch XTCOM_UTIL.
  3. In the Tools menu choose Config Device and set the Com port and set the baud rate to the value you used during testing (57600 or 115200). Click Open but don't close this panel.
  4. From the API TEST(A) menu choose Flash Image Download and browse to the downloaded firmware .bin file
  5. Click DownLoad to start the update - the progress bar will confirm it's under way.
  6. That's it!

Testing

On completion of the update, disconnect GPIO0 from ground and re-cycle the power. You can now use the serial connection to try a few AT commands. NB: Following the update the default serial baud rate changes to 9600 and AT commands require a CR/LF combination to enter commands.

esp8266_firmware_update.1415458322.txt.gz · Last modified: 2020/06/27 23:02 (external edit)