User Tools

Site Tools


guides:lpc810_win

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
guides:lpc810_win [2014/08/25 13:11]
chrisstubbs
guides:lpc810_win [2020/06/27 23:02] (current)
Line 58: Line 58:
  
 ===== Testing ===== ===== Testing =====
-Disconnect the short between pins 3&4 on the header, then move the cable from pin 2 over to pin 3. Connect to the COM port at 9600 baud using putty or the arduino serial monitor then power cycle the board. You should see "done" appear as the board boots. Packets should pop up at 869.500MHz every 200 seconds which you can check with an SDR.+Disconnect the short between pins 3&4 on the header, then move the cable from pin 2 over to pin 3. Connect to the COM port at 115200 baud using putty or the arduino serial monitor then power cycle the board. You should see "done" appear as the board boots. Packets should pop up at 869.500MHz every 200 seconds which you can check with an SDR.
  
 {{:guides:lpcwindebug.jpg?200|}} {{:guides:lpcwindebug.jpg?200|}}
guides/lpc810_win.txt ยท Last modified: 2020/06/27 23:02 (external edit)