User Tools

Site Tools


phil_crump_gen1_nodes

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
phil_crump_gen1_nodes [2014/05/09 01:24]
craag created
phil_crump_gen1_nodes [2020/06/27 23:02] (current)
Line 59: Line 59:
   * 1x Molex MicroUSB - [[http://uk.farnell.com/molex/47346-0001/micro-usb-type-b-receptacle-bottom/dp/1568026?Ntt=1568026|Farnell 1568026]]   * 1x Molex MicroUSB - [[http://uk.farnell.com/molex/47346-0001/micro-usb-type-b-receptacle-bottom/dp/1568026?Ntt=1568026|Farnell 1568026]]
   * 1x JST 2mm 2way - [[http://uk.farnell.com/jst-japan-solderless-terminals/s2b-ph-sm4-tb-lf-sn/connector-header-smt-r-a-2mm-2way/dp/9492615|Farnell 9492615]]   * 1x JST 2mm 2way - [[http://uk.farnell.com/jst-japan-solderless-terminals/s2b-ph-sm4-tb-lf-sn/connector-header-smt-r-a-2mm-2way/dp/9492615|Farnell 9492615]]
 +
 +==== PCB V2 ====
 +
 +**TODO:**
 +  * Remove 2x Large Reservoir capacitors - not required
 +  * USB Vcc connected to USB Vin on KL25z board - will also charge from KL25z USB sockets.
 +  * Use larger SMA socket footprint - For UK-available parts
 +  * Add jumper to switch off KL25/Radio supply from lipo/charger - allow switching off/isolating lipo charging
 +    * 40mA Precharge Current for dead lipo was barely enough to power board, let alone charge the Lipo as well.
phil_crump_gen1_nodes.txt ยท Last modified: 2020/06/27 23:02 (external edit)